Turn off the dash cam and remove the Micro SD card from the device. Copy/paste or drag/drop the latest version of the firmware you downloaded from above into the root directory of the Micro SD card folder on your computer.
DO NOT place it in a subfolder on the Micro SD card.
Step 2
Insert the Micro SD card with the updated firmware into the Dashcam when the Dashcam is powered on.
Step 3
Once the Dashcam recognizes the Micro SD card a dialog box will pop up asking if you want to update the system. Tap OK, and the system will begin to update automatically.
DO NOT power off or unplug your Dashcam while updating the firmware. Otherwise, this will cause damage to the operating system.
Ensure the power cable is firmly and fully connected.
Make sure the socket of your vehicle’s auxiliary power outlet is clean and free of corrosion or other damages.
Make sure the power cable is firmly and fully seated in the auxiliary power outlet.
Check to make sure the car fuse for the auxiliary power outlet has not been tripped.
Turn off the Dashcam by pressing and holding the power button for eight seconds. Press it again to turn the unit back on.
Please make sure that both the front and rear camera lenses are clean and are free from fingerprints or smudges. Please clean both lenses using an approved lens cleaning solution, or with rubbing alcohol.
Ensure that you have removed the protective film off the lens.
Make sure the windshield around the camera lens is clean and free of dirt and debris. Both inside and outside of the vehicle.
Please go to the preview interface to see if you can see the image from the rear camera.
If yes, please verify whether the red trigger wire on the rear camera extension cable is electrically tied to the reversing lamp positive lead.
If not, please check all of the connections leading to the rear camera to ensure that the camera is plugged into the system. Or reboot the device. If it still doesn't work, please contact us at cs@nexigo.com at any time for further assistance.
Turn off the dash cam and remove the Micro SD card from the device. Using a card reader, insert the Micro SD card into your computer. You can then transfer files from the Micro SD card onto your computer.
Note: Do not insert or remove the Micro SD card while it is saving or reading data. The data may be damaged or lost. Only insert or remove the Micro SD card when the dash cam is turned off.
Notes: Registration code: A registration code can only be used on one computer. The registration code is available on the GPS Infor section of User Manual.
